Every aspect of the patented KeelGuard has been designed with boat designers and 3M engineers. Many factors contribute to its success. A precise, abrasive-resistant blend of polymers and urethanes achieve optimal durability and pliability. A pressure-sensitive adhesive creates strength, while permanently bonding and sealing KeelGuard’s contoured edges to the hull surface. Angled grooves produce hydrodynamic channels, creating air pockets and providing a slicker surface. The perfect combination of these factors makes the Megaware KeelGuard the easiest keel protector to install, and give it unparalleled quality and dependability.

The KeelGuard is a very simple product to install; however, the following instructions must be strictly followed. Any short cuts or missed steps will jeopardize and compromise the full bonding capabilities of the 3M adhesive. For best results the KeelGuard should be installed at an ambient temperature of 60º or above.

Typically, the KeelGuard is mounted 4 to 6 inches above the waterline on the bow, ending 2 to 3 feet or more beyond the lowest point of the Keel. If protection is required above the Boweye, a separate Bow Guard is available in 1ft to 3ft lengths. For personal watercraft*, begin the KeelGuard approximately 1 inch below the bow hook, running the length of the keel, and ending 4 to 6 inches forward of the pump intake.

• Protect against abrasive sand, rocks, concrete ramps and oyster beds


• Eliminate costly repairs


• Enjoy the highest quality and superior engineering


• Increase the value of your boat

Wear and damage to your boat’s keel can break down its protective gelcoat finish, allowing water to reach and destroy the fiberglass laminates.

4 ft for up to 14ft boat length

5 ft-  15-16ft

6ft - 17-18ft

7 ft - 19-20ft

8 ft -21-22ft

9 ft - 23-24ft